6.3
Setting the parameters in the Installer level
Fig.4
Access to the installer level
4x
2x
Fig.5
Setting full load
1x
Fig.6
Setting low load
1x
7698035 - v.01 - 19022018
Parameters at installer level (see table of parameters) may be modified
only by a recognised installer. To prevent unwanted modifications to set
tings, some parameters can only be changed after the special access
code
1. Navigate to the Installer menu.
The
2. Select the installer menu using the
3. Using the
4. To confirm, press the
appears.
5. Press the
The value
6. Change the value by pressing the
to
°C, for example, using the
7. Press the
appears.
8. Set any other parameters by selecting them using the
9. Press the
Important
The main menu will appear even if no keys are pressed for 3 mi
nutes.
AD-4000048-01
6.3.1
Setting full load
1. Press the
The
2. Wait a while until
Full load has now been set.
AD-4000053-01
6.3.2
Setting low load
1. Press the
The
2. Wait a while until
3. Press the
Low load has now been set.
AD-4000054-01
is entered.
symbol flashes in the menu bar.
appears on the display.
or
keys, set the installer code
key.
key.
°C will appear (factory setting).
key to confirm the value.
key twice to go back to the main display.
key.
symbol will appear in the display.
appears in the display.
key.
symbol will appear in the display.
appears in the display.
key until
appears on the display.
6 Settings
key.
.
or
keys. Reduce the value
key.
or
keys.
11