Setting Mode User Level (X - REMEHA Quinta 45 Technical Information

One or several adjusted parameters out of range including some
B$#
factory defaults which should not have been changed. Check and reset
parameters:
- Press the 'reset'-key imidiately followed by pressing the 'm'-key for
about 12 sec
- 'code'- display shows P
- Use [+] and [-]-keys to enter correct boiler parameter (Quinta 45:
P=44; Quinta 65: P=64
- Press 'e'-key to confirm settings
- Check parameter settings and change where necessary or wanted.
Table 05 Shut-off codes
NOTE: Shut-off mode is a normal boiler operating function and does not represent a
boiler failure. However, this may indicate a system problem, an internal boiler check or
an incorrect parameter setting.

6.5 Setting mode user level (X[[)

Code Description
Flow temperature set
!
point
Pump run on time HTG
@
DHW temperature set
#
point
Boiler control setting
A
Base point internal
u
compensation slope
Table 06 Setting mode user level
Note: Changing code @ and code A should only be on design engineers advice
55979.indd 22 55979.indd 22
Setting range
20-90 ºC
00
= pump run on
10 seconds
01-15 = pump run on in minutes
20-75 °C (only with sensor)
Control mode (modulating-on/off etc.)
n/a
22
Remeha
Quinta 45/65
Preset
80
03
55
11
20
2-4-2009 9:42:38 2-4-2009 9:42:38