Keysight Technologies InfiniiVision 4000 X Series Programmer's Manual page 4

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
4
Chapter 10, ":CALibrate Commands," starting on page 331, describes utility
commands for determining the state of the calibration factor protection button.
Chapter 11, ":CHANnel<n> Commands," starting on page 343, describes
commands that control all oscilloscope functions associated with individual
analog channels or groups of channels.
Chapter 12, ":COMPliance Commands," starting on page 367, describes
commands that control the USB 2.0 signal quality analysis feature.
Chapter 13, ":COUNter Commands," starting on page 379, describes
commands that control the counter analysis feature.
Chapter 14, ":DEMO Commands," starting on page 385, describes commands
that control the education kit demonstration signals that can be output on the
oscilloscope's Demo 1 and Demo 2 terminals.
Chapter 15, ":DIGital<d> Commands," starting on page 393, describes
commands that control all oscilloscope functions associated with individual
digital channels.
Chapter 16, ":DISPlay Commands," starting on page 401, describes commands
that control how waveforms, graticule, and text are displayed and written on
the screen.
Chapter 17, ":DVM Commands," starting on page 427, describes commands
that control the digital voltmeter analysis feature.
Chapter 18, ":EXTernal Trigger Commands," starting on page 433, describes
commands that control the input characteristics of the external trigger input.
Chapter 19, ":FRANalysis Commands," starting on page 439, describes
commands that control oscilloscope functions associated with the Frequency
Response Analysis (FRA) feature, which is available is with the license-enabled
built-in waveform generator).
Chapter 20, ":FUNCtion<m> Commands," starting on page 455, describes
commands that control math waveforms.
Chapter 21, ":HARDcopy/:HCOPY Commands," starting on page 503,
describes commands that set and query the selection of hardcopy device and
formatting options.
Chapter 22, ":LISTer Commands," starting on page 523, describes commands
that turn on/off the Lister display for decoded serial data and get the Lister
data.
Chapter 23, ":MARKer Commands," starting on page 527, describes commands
that set and query the settings of X-axis markers (X1 and X2 cursors) and the
Y-axis markers (Y1 and Y2 cursors).
Chapter 24, ":MEASure Commands," starting on page 549, describes
commands that select automatic measurements (and control markers).
Chapter 25, ":MEASure Power Commands," starting on page 641, describes
measurement commands that are available when the power measurements and
analysis application is licensed and enabled.
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide