Keysight Technologies InfiniiVision 4000 X Series Programmer's Manual page 54

1
What's New
Command
:SBUS<n>:LIN:TRIGger:SYMBol
ic:VALue (see
:SEARch:SERial:LIN:SYMBolic:F
RAMe (see
:SEARch:SERial:LIN:SYMBolic:
SIGNal (see
:SEARch:SERial:LIN:SYMBolic:
VALue (see
:WGEN<w>:OUTPut:MODE (see
page
:WGEN<w>:OUTPut:SINGle
(see
Changed
Commands
Command
:SBUS<n>:LIN:TRIGger (see
page
:SEARch:SERial:LIN:MODE (see
page
54
page 991)
page 1221)
page 1222)
page 1223)
1467)
page 1469)
982)
1217)
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Description
Specifies signal value to trigger on when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN trigger
mode is set to FSIGnal.
Specifies the message to search for when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN serial
search mode is set to FRAMe or FSIGnal.
Specifies signal to search for when LIN symbolic data has been
loaded (recalled) into the oscilloscope and the LIN serial search
mode is set to FSIGnal.
Specifies signal value to search for when LIN symbolic data has
been loaded (recalled) into the oscilloscope and the LIN serial
search mode is set to FSIGnal.
Specifies whether the defined waveform is output continuously or
as a single cycle (single-shot).
When the single-shot output mode is selected, this command
causes a single cycle of the defined waveform to be output.
Differences
You can now trigger on symbolic frames (with parameter FRAMe)
or frames and signal values (with parameter FSIGnal).
You can now search for symbolic messages (with parameter
FRAMe) or frames and signal values (with parameter FSIGnal).