Constant Speed - MAHA POWERDYNO MSR Series Original Operating Instructions

76
Pos: 276 /Te chnis che Dok umenta tion/A lle G eräte/ Überschr ifte n/Üb erschrif te n 1.1.1/ K/Übersc hrift 1.1.1: K ons ta nte Ges chw ind igk eit @ 13\m od_1234771175104_ 75.docx @ 339725 @ 3 @ 1
10.1.3

Constant Speed

Pos: 277 /Te chnis che Dok umenta tion/ Leis tungsmesstechnik/POWE RDYNO/052301 LPS 3000 R100/BA/Inhalt: 0523 K onsta nte Ges chw ind igkeit @ 13\m od_1234771607616_ 75.docx @ 339751 @ @ 1
With the operating mode
speed remains constant independent from the traction (from low to full throttle) created by the
vehicle, i.e. only the the speed which was pre-set can be driven. Only the eddy current brake
effectiveness increases up to full throttle but not the speed.
1 Position the vehicle on the dyno and fix it.
2 Call up the menu LOAD SIMULATION and
then the menu point CONSTANT SPEED.
 The following screen appears:
3 Enter the target value of the speed
into the entry box
4 Use the button <F8 CONTINUE>.
 The measurement screen appears.
The entered speed must be higher than 7 km/h.
5 Start the measurement.
6 Use the button <F6> to start or stop the
graphic recording of the measurement.
Pos: 278 /-----Format- ----/MANUE LLE R UMBRUCH Se ite numbruch @ 0\mod_ 1134403577687_0.docx @ 1277 @ @ 1
BA053101-en
Constant Speed
the dyno is regulated in such a way that the driving
v-target
via the digit keys.