Safety; Introduction; Symbols; Intended Use - MAHA POWERDYNO MSR Series Original Operating Instructions

Pos: 6 / Te chnisc he Dokum entation/A lle Gerä te/ Überschrif te n/Übersc hriften 1/S/ Überschrift 1: Sicherheit @ 6\mod_ 1174482399906_75.d ocx @ 76962 @ 1 @ 1
1

Safety

Pos: 7 / Te chnisc he Dokum entation/A lle Gerä te/ Überschrif te n/Übersc hriften 1.1/E/Übersc hrif t 1.1: E inf ührung @ 6\m od_1174482219062_ 75.docx @ 76793 @ 2 @ 1
1.1

Introduction

Pos: 8 / Te chnisc he Dokum entation/A lle Gerä te/Inhalte/S ic herhe it/Inha lt: Einf ührung Sicher heit @ 6\mod_ 1175609639562_ 75.docx @ 87528 @ @ 1
Thoroughly read this manual before operating the equipment and comply with the instructions.
Always display the manual in a conspicuous location.
Personal injury and property damage incurred due to non-compliance with these safety
instructions are not covered by the product liability regulations.
Pos: 9 / Te chnisc he Dokum entation/A lle Gerä te/ Überschrif te n/Übersc hriften 1.1/S/ Überschrift 1.1: Symbole @ 6\mod_ 1174482270875_ 75.docx @ 76865 @ 2 @ 1
1.2

Symbols

Pos: 10 / Tec hnische Dokume ntation/Alle Geräte/Inhalte/Sicherhe it/Inhalt: Symbole S ic herheit @ 14\mod_ 1239866667866_75.d ocx @ 361518 @ @ 1
Important safety instructions. Failure to comply with instructions could result in personal injury or
property damage.
Important information.
Pos: 11 / Tec hnische Dokume ntation/Alle Geräte/Übersc hriften/ Überschrifte n 1.1/B/ Überschrif t 1.1: Bes timm ungsgemä ßer Gebrauch @ 6\m od_1176734022203_ 75.d ocx @ 88746 @ 2 @ 1
1.3

Intended Use

Pos: 12 / Tec hnische Dokume ntation/Le istungsmess tec hnik/- Arc hiv -/00 LPS A lle/Inhalte/Inhalt: Bes timm ungs gemä ßer Gebra uch LP S @ 22\m od_1289554938563_ 75.d ocx @ 939803 @ @ 1
This dynamometer is to be used exclusively for the performance testing of motor vehicles. It is not
suitable for brake testing or noise detection. Observe the rated axle load.
The equipment may not be modified without the express written consent of the manufacturer. In
case of non-compliance the declaration of conformity becomes void.
Pos: 13 / Tec hnische Dokume ntation/Alle Geräte/Inhalte/Sicherhe it/Inhalt: Bes timm ungsw idriger Gebrauch allg @ 20\mod_ 1269438225062_75.d ocx @ 828842 @ @ 1
Any use other than described is inappropriate.
Pos: 14 / Tec hnische Dokume ntation/Alle Geräte/Übersc hriften/ Überschrifte n 1.1/S/Übersc hrif t 1.1: S ic herhe itsvorschr iften f ür die Inbe trieb nahm e @ 6\m od_1174482269156_ 75.docx @ 76838 @ 2 @ 1
1.4

Safety Instructions for Commissioning

Pos: 15 / Tec hnische Dokume ntation/Le istungsmess tec hnik/- Arc hiv -/00 LPS A lle/Inhalte/Inhalt: Sicher heitsvorsc hrif ten für d ie I nbetriebna hme LPS @ 22\mod_ 1290588545708_ 75.docx @ 946285 @ @ 1
• Only authorized service technicians may install and commission the test stand.
• The test stand may not be installed and operated in fire-endangered operation facilities, outside
or in damp rooms (e.g. wash halls).
• Mount components of the vehicle fixing unit in advance on a suitable lift on the test stand.
• Warning stickers must be attached by the operator:
– Hearing damage due to high noise level. Wear hearing protection.
– Severe eye injuries due to flying particles. Wear protective goggles! Operator is responsible.
• Wear personal protective clothing as required or as regulated by law. The personal protective
clothing must meet the safety-technical regulations for the respective work application.
Pos: 16 /----- Forma t-----/MAN UELLER UM BRUCH Se itenumbruch @ 0\m od_1134403577687_ 0.docx @ 1277 @ @ 1
7
BA053101-en