Status Led During Inverter Mode; Checking Battery Status - Xantrex Freedom HF 1000 Owner's Manual

Status LED During Inverter Mode

Table 4-1 Status LED during Inverter Mode
Status LED Display Screen
12.8
Solid
YELLOW
(where 12.8 is an
example of battery
voltage)
11
(where 11 is an
example of current)
0.85
(where 0.85 is an
example of output
power in Kilowatts)
E05
E01
Solid RED
Off Off
00
Off (or Yellow)

Checking Battery Status

975-0390-01-01
The following summarizes the behavior of the Status LED during Inverter
mode.
Condition
Select button is pressed to display Input Battery Voltage.
The Input Battery Voltage LED lights up.
Value in display screen is shown as Volts.
Select button is pressed to display Input Current.
The Input Current LED lights up.
Value in display screen is shown as Amps.
Select button is pressed to display Output Power.
The Output Power LED lights up.
Value in display screen is shown as Kilowatts.
e07
Warning condition detected while AC output power is still
through
available.
See
Screen" on page
e04
Fault condition detected and AC output power is not
through
available. The unit will sound an alarm and will shutdown
completely within 30 seconds.
See
Screen" on page
Inverter is OFF.
0
No communication between the
.
Panel because the battery voltage was too low to start the
Inverter.
During inverter mode, you can check the battery status by pressing the
Select button until the Input Voltage LED (or Input Current LED)
illuminates. The battery voltage (or battery current) appears in the three-
digit LED display screen when the Input Voltage LED (or Input Current
LED) illuminates.
The normal operating battery voltage range is between 11 and 15 volts.
Table 5-1, "Error Codes Displayed on the Display Panel
5–5.
Table 5-1, "Error Codes Displayed on the Display Panel
5–5.
Operating in Inverter Mode
Freedom HF and the Display
4–5