Onboard Status Led Panel - Xantrex XPLORE 120/12 Owner's Manual

Onboard Status LED Panel

Onboard Status LED Panel
This section describes the parts of the onboard status LED panel
of the XPLORE Charger. See Reading Onboard Display LEDs on
page 1 for more information.
Figure 3 Onboard Status LED Panel
Item
Bank LEDs
- displays the status of BAT1 (group 1). Solid green
n
indicates battery is connected and detected. Off means
battery is not present.
- displays the status of BAT2 (group 1). Solid green
n
indicates battery is connected and detected. Off means
battery is not present.
n
BAT6 (group 2). Individual solid green indicates each
battery is connected and detected. Off means a battery
is not present.
8
Description
- displays the status of BAT3-
Item
Status LEDs
Solid - battery is fully charged (float stage).
n
Flashing - battery is being charged (bulk and
n
absorption stages). A 0.5 Hz flashing sequence
indicates 0 to 25% SOC, 1 Hz = 25 to 50% SOC, 1.5 Hz =
50 to 75% SOC, and 2 Hz = 75 to 100% SOC.
Battery
Select button - a short press will scroll through each
n
Type LEDs
and Select
of the battery types in sequence. A long press while on a
button
selected battery type will confirm that battery type.
n
indicates that battery type is selected. A flashing green
indicates that an active selection is being made.
Charger
Status LEDs
- a solid green indicates AC power is available and
n
unit is able to charge.
- a solid green indicates charger is in energy saving
n
mode. A flashing green indicates the charger is in
standby mode, in booting up mode, or in event mode.
- a solid red indicates that the charger has detected
n
an event and charging at the output terminals is
disabled.
XPLORE 120/12 Battery Charger Owner's Guide
Description
- a solid green on any of the LEDs