Pre-Start Instructions - Progressive Turf Equipment Slope-Pro Operator's Manual

Pre-start Instructions

Pre-start Instructions
BEFORE OPERATING THIS MACHINE
Check that the Operator's Manual is located in the manual container
and is in good condition. Contact your dealer immediately if you do
not have an Operator's Manual
Carefully read the Operator's Manual, completely understand the
Safety Messages and instructions, and know how to correctly operate
this machine. Contact your dealer for an explanation of any
instruction not fully understood.
Verify that all safety decals are in place and legible, guards and
covers are in place and properly secured / positioned.
1. Check Engine Oil
Check engine oil daily or before each use. If low, add oil. Do not
overfill.
Make sure the machine is parked on level ground. The engine must
be OFF and allowed to cool.
▪
Clean any debris from around the dipstick to prevent oil
contamination.
▪
Withdraw dipstick and wipe off oil.
▪
Re-insert dipstick fully, then remove to check. Oil should be up
to, but not over the F (full) mark on the dipstick.
▪
If the oil level is low, add until it is up to the F mark. The filler
cap is located on the left-hand side of the engine.
▪
Add oil in small amounts and recheck with the dipstick before
adding more.
▪
Reinstall the filler cap and make sure the dipstick is secure.
IMPORTANT! Ensure oil level is at the F (full) mark for steep
slope operation.
To prevent extensive engine wear or damage, always
maintain proper oil level in the crankcase. Never operate the
engine with the oil level below the L (low) or above the F
(full) marks on the dipstick.
2. Check Fuel Level and Tank Security
The fuel tanks are accessed inside the front hood. Each tank has a
sight level gauge. Only one tank is used at a time. A quarter-turn
valve is located between the tanks to select the active fuel tank.
Verify that tanks are secure and straps are in good condition.
If fuel is required, remove the tank from the machine.
▪ Disconnect the fuel tank's vent line and remove the tank strap.
▪
Depress the latch on the fuel line connector and pull the hose
off of the spigot.
▪
Remove the tank and refuel in a well-ventilated area away from
the machine.
▪
When installing the fuel tank, ensure connector is clean.
Reconnect vent line, fuel line, and tank strap. Wipe up any
spilled fuel.
▪
Ensure that the air inlet valve is open on the operating tank.
22
Operator's Manual
®
Slope-Pro
RH TANK LH TANK