Assembly Instructions - Progressive Turf Equipment TDR-X Operator's Manual & Parts List

TDR-X Operator's Manual

ASSEMBLY INSTRUCTIONS

Mower assembly must be completed by a qualified technician
using safe work practices and proper tools.
INPUT SHAFT – shipped strapped to wing deck swivel
Remove ½" UNC retaining bolt/nut from input shaft.
1.
2.
Remove notification tag from intermediate shaft hanger bearing.
IMPORTANT - Ensure gold colour spacer ring is present against bearing inner race.
3.
Disconnect input shaft shield at clamp yoke end and
slide shield exposing the clamp yoke (see input shaft
service instructions in mower manual storage tube).
4.
Place the Input shaft on the provided support.
5.
Install input shaft clamp yoke on intermediate shaft,
ensuring gold coloured spacer ring is in place between
the input shaft yoke and hanger bearing race.
Reinstall ½" UNF retaining bolt in input shaft yoke,
6.
torque to 85 ft-lb.
7.
Reinstall input shaft shield per input shaft service
instructions.
8.
Fasten input shaft guard retaining chain to mower main
frame.
If the PTO shaft comes off during operation, it may cause
personal injury and damage to the PTO shaft and tractor
PTO. When checking, make sure the locking collar is
locked, and that the shaft is not just jammed against the end
of the tractor PTO shaft.
16
SLIDE SHAFT
SHIELD BACK
INPUT PTO SHAFT
SUPPORT