Assembly Instructions; Set-Up; Wing Decks - Progressive Turf Equipment TDR-30 Operator's Manual And Parts List

ASSEMBLY INSTRUCTIONS

SET-UP

The mower is shipped in a 90% assembled condition to facilitate
shipping of the mower in enclosed vans. Approximately 1 1/2
hours are required to complete the mower to field ready
condition. Assembly will be easier if components are aligned and
loosely assembled before tightening hardware. Recommended
torque values are found on page 44. Select a suitable working
area. A tractor or portable hydraulic supply is necessary to
complete assembly.
Assembly should be completed by a competent individual who
has an understanding of safe machinery operation practices and
tool operation. Always use personal protection devices such as
eye and ear protection during assembly. Ensure the area is free
of hazards and can accommodate the assembly of the mower

WING DECKS

1) With the mower parked in a level work area, place deck spreader fixture (PTE 526498) underneath the
mower frame, centered between the wing decks on the floor, see photos below. This spreader prevents
the decks from swinging beneath the mower frame when the wings are initially lowered, allowing for
proper deck swivel pin alignment in subsequent steps.
If the 526498 deck spreader is unavailable, an alternative is to place suitable wood blocking under the
frame with a width of 75.5 in. The blocking must be arranged so that the decks cannot swing under the
main frame when lowered from the transport position.
TDR-30 Operator's Manual
17