Progressive Turf Equipment Slope-Pro Operator's Manual page 27

Operator's Manual Pre-start Instructions
®
Slope-Pro
Remove the gas tank from the machine to fuel up. Gasoline
and gasoline vapors are extremely flammable and can
explode if ignited causing fires and severe burns. Refill the
fuel tank outdoors or in a well-ventilated area. Clean up
spilled fuel immediately.
Reconnect fuel supply and vent lines before operating the
engine. In order to comply with emissions regulations, both
fuel supply and vent lines must be connected at all times.
Failure to do so will result in abnormal engine operation.
DO NOT run the machine with the hood open.
3. Check Cooling Areas
Make sure rear screen, hydraulic oil cooler and engine surfaces are
kept clean and free of debris.
If dust build-up is present between the hydraulic cooler fins, the
cooler cover will pivot up for cleaning by loosening the (2) wing bolt.
The electric cooling fan may start without notice and discharge dust,
always protect your eyes with proper safety equipment.
In some cases where the mowing conditions are extremely dry, grass
debris may collect on the rear screen. If this happens, run the
machine in reverse to help avoid the problem.
4. Air Cleaner
Check the air cleaner daily before starting the engine for dirt and
debris. Remove the cover and remove any loose debris or material
from the filter element.
IMPORTANT! Running the engine with loose or damaged air
cleaner components could allow unfiltered air into the
engine, causing premature engine wear or failure.
5. Drive Belts
Open the front hood and check condition of all drive belts.
Check both of the main drive belts on the engine output shaft.
Check both mower drive belts. Look for cracking or wear.
Clean any debris from this area.
23