Cold Weather Operation; Stopping The Engine - Progressive Turf Equipment Slope-Pro Operator's Manual

Remote controlled slope mower
Table of Contents

Advertisement

Operator's Manual
®
Slope-Pro
Push the Engine Start toggle switch forward to engage the
starter. Release when the engine starts.
Once the engine is running, verify the Check Engine and Low
Engine Oil Pressure warning lamps on the console are OFF. If
they are NOT off, stop the engine immediately and have a
qualified technician rectify the problem.

Cold Weather Operation

Ensure the proper oil viscosity is used for the anticipated
ambient temperature. See page 40.
Allow engine and hydraulic system to warm up for 15 minutes
before operating machine in temperatures below 10ºC (50ºF).
If it is anticipated that the machine will encounter temperatures
below 7ºC (37ºF) it is recommended to store machine indoors if
using the factory fill hydraulic oil.
Remove mud and debris from machine prior to shutdown.
Engine exhaust gases contain poisonous carbon monoxide.
Carbon monoxide is odorless, colorless, and can cause
death if inhaled. Do not run engine in confined areas.

Stopping the Engine

IMPORTANT! Run engine at idle for 5–10 minutes before
shut down to allow internal engine components to cool.
Pull the engine start /stop control switch on the remote control
rearward towards the operator to the off position.
On the control panel, turn the key switch counter-clockwise to
the OFF (O) position.
Turn the remote on/ off switch to the OFF position.
NOTE! Engine cannot be re-started for 5 seconds after
activating the engine stop function.
Operating Instructions
27

Advertisement

Table of Contents
loading

Table of Contents