Progressive Turf Equipment Slope-Pro Operator's Manual page 64

DAILY PRE-OPERATION INSPECTION CHECKLIST
Before conducting the inspection, always observe proper lock-out procedures when performing any
maintenance work. Always remove and retain the ignition key, block and or support machine using
equipment designed for the task. Be aware of hot areas and ensure the hood strut lock is functioning
properly and can adequately hold open the hood.
Pre-Start Checks Prior to Operating
Ensure Operator's Manual is stored within manual
container on machine
Verify that all safety decals are legible
Ensure the horn is operational
Check engine oil level – on level ground
Check fuel level and tank security (both)
Check cooling area
Check air cleaner and connections
Check drive belts
Check for and remove any debris
Check hydraulic tank level and for signs of leakage
Check tracks for correct adjustment
Check height adjustment
Verify mower blades, spindles are in good condition
and properly secured
Hoods and guards are in good condition and in place
Check all fasteners
Functional Checks Prior To Operating
Ensure horn sounds when communication is
established between remote control and machine
Ensure emergency stops on remote control and
machine operate properly
Ensure excessive tilt angle shut down functions on
remote control
Verify that flashing light illuminated when machine is
in motion
Verify that all operation controls function correctly
Verify that PTO clutch functions correctly
OPERATORS SIGNATURE___________________________________
This Pre-Operation Inspection form may be duplicated for extra copies.
MOWER ID#
DATE
DO NOT OPERATE AN UNSAFE MOWER
PERFORMED BY
Supervisor
Operator
SHIFT
Condition at Specific Comments
Start of Shift if not O.K.
PAGE 2 OF 2