Control Function Of An Infrared Remote Control Module - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 2 Add an infrared remote control module.
1.
2.
Table 7-3 Adding infrared remote control module
Path
System
Settings >
Device
Management
3.
----End

7.6.3 Control Function of an Infrared Remote Control Module

Prerequisites


Issue 02 (2019-02-28)
The infrared remote control module address is set to 2 by default.
Log in to the ECC800 WebUI as an administrator.
Add an infrared remote control module.
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the infrared remote control module connects to the
ECC800 properly.
a. If the infrared remote control module connects to the ECC800 properly, click Add
Device.
b. If the infrared remote control module does not connect to the ECC800 properly,
check whether the cable between the infrared remote control module and the
ECC800 is connected properly, whether the infrared remote control module and
ECC800 are running properly, and whether the input parameters are the consistent
with the infrared remote control module parameters.
The infrared remote control module has connected to the ECC800e, and the infrared
remote control module and ECC800e are powered on.
You have obtained the IP address of the ECC800e as well as the user name and password
used for WebUI login.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Infrared Remote Control Module from the
drop-down list box.
Select ECC800 from the drop-down list box.
Select COM2 from the drop-down list box.
NOTE
By default, an infrared remote control module is
connected to port COM2 on the ECC800. If the infrared
remote control module is connected to another port, set
the COM port to the ECC800 port connected to the
infrared remote control module.
In this example, set Device address to 1. Set the
actual device address of the infrared remote control
module during operations.
7 Feature Description
179