Setting And Adding A Hydrogen Detection System - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Procedure
Step 1 Set monitoring parameters for the AC meter.
1.
2.
3.
Step 2 Add the AC meter.
1.
2.
Table 5-19 Setting parameters for the AC meter
Path
System
Settings >
Device
Management
3.
----End

5.3.21 Setting and Adding a Hydrogen Detection System

Context
In this example, the hydrogen detection system is connected to the COM1 port on the
ECC800.
Procedure
Step 1 Set monitoring parameters for the hydrogen detection system.
Issue 02 (2019-02-28)
On the AC meter screen displayed after the startup, press E to go to the login screen.
Type the password 1000, and press H to go to the Settings screen.
Press H to go to the Address Settings screen. Then, set Communication Address to 1
(value range: 1-247) by pressing the up and down keys, and press H.
Log in to the ECC800 WebUI as an administrator.
Add the AC meter.
Parameter
Name
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the AC meter connects to the ECC800 properly.
− If the AC meter connects to the ECC800 properly, click Add Device.
− If the AC meter does not connect to the ECC800 properly, check whether the cable
between the AC meter and the ECC800 is connected properly, whether the AC
meter and ECC800 are running properly, and whether the input parameters are the
consistent with the AC meter parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select AC Meter from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM2 from the drop-down list box.
NOTE
The setting example indicates that the AC meter is
connected to the COM2 port on the ECC800. If the AC
meter is connected to another port, set the number of the
connected port.
In this example, set Device address to 1. Set the
actual device address of the AC meter during
operations.
5 Power-On Commissioning
117