How Should I Add Devices Accessed Through The Ecc800 Com Port To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 2 Add the device to the ECC800 WebUI.
1.
2.
Table 9-2 Parameter description for adding a device
Path
System
Settings >
Device
Management
3.
4.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800 WebUI, and drag the device to the corresponding
position in the Smart Module View pane based on the actual device layout.
9.1.22 How Should I Add Devices Accessed Through the ECC800
COM Port to the ECC800 WebUI
Prerequisites
This section uses the device connecting to the COM1 port on the ECC800 as an example.
Issue 02 (2019-02-28)
Log in to the ECC800 WebUI as an administrator.
Add the device.
Parameter
Device type
Connect to
Communications
port
Device address
Click Connect Test to check whether the device connects to the ECC800 properly.
− If the connection is proper, click Add Device.
− If the connection is not proper, check that the cable is properly connected between
the device and the ECC800, that the device and ECC800 are running properly, and
that the input parameters are consistent with the device parameters.
Choose Monitoring > System > ETH Converter Group > ETH Converter n >
Running Parameters and set Device name to ETH Converter_device position.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select the device to be accessed from the
drop-down list box.
Select the corresponding ETH converter from the
drop-down list box.
NOTE
Use the blinking function of the ETH converter to identify
the mapping between the device and the ETH converter.
Select COM1/COM2 from the drop-down list box.
This section uses 1 as an example. In practice, set
this parameter to be the same as the
communications address for the device.
9 FAQ
211