Bim - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Networking Switch
Table 3-72 Networking switch description
Name
Button pressing
Button pressing
Button holding down
Default Button
Table 3-73 Default button description
Name
Default button

3.3.20.2 BIM

The BIM is a battery monitoring module that monitors the voltages, internal resistances, and
pole temperatures of batteries and supports 12 V power.
Features



Issue 02 (2019-02-28)
 Blinking intermittently at super short intervals means an indicator blinks at super short intervals for
0.5s and then remains off for 0.5s.
Monitors the voltages, internal resistances, and pole temperatures of 12 V batteries.
Supports the hibernation function. (When it detects that the battery voltage is low, it will
enter the low-power mode.)
Communicates with the CIM wirelessly.
Copyright © Huawei Technologies Co., Ltd.
Definition
Press the button for
less than 1s.
Press and hold the
button for more than
1s but less than 5s.
Press and hold the
button for more than
10s but less than 20s.
Definition
Hold down the button
for more than 10
seconds.
3 Device Description
Function
CIM blinking function
Creates a network if no network has
been created. Switches between network
organization and data transmission if a
network has been created.
Clears the current network (including
the network parameters of all the online
BIMs).
Function
Reset to the default IP address
(192.168.0.10)
76