Control Function Of An Infrared Remote Control Module - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 7-3 Adding infrared remote control module parameters
Parameter Name
Communications port
Device address
4.
----End

7.6.3 Control Function of an Infrared Remote Control Module

Prerequisites



Context


Procedure
Step 1 Set functions of infrared remote control module on the WebUI.
1.
2.
3.
4.
5.
Issue 06 (2020-01-02)
Setting
Select COM2 from the drop-down list box.
In this example, set Device address to 1. Set the actual device
address of the infrared remote control module during operations.
Click Connect Test to check whether the infrared remote control module connects to the
ECC800 properly.
a. If the infrared remote control module connects to the ECC800 properly, click Add
Device.
b. If the infrared remote control module does not connect to the ECC800 properly,
check whether the cable between the infrared remote control module and the
ECC800 is connected properly, whether the infrared remote control module and
ECC800 are running properly, and whether the input parameters are the consistent
with the infrared remote control module parameters.
The infrared remote control module has connected to the ECC800e, and the infrared
remote control module and ECC800e are powered on.
You have obtained the IP address of the ECC800e as well as the user name and password
used for WebUI login.
A PC with an IP address in the same network segment as that of the ECC800e is
prepared, and the PC has connected to port WAN on the ECC800e.
The infrared remote control module supports self-learning and can remotely control the
startup of the civil smart cooling product.
The infrared remote control module can be in infrared learning state and control code
sending state. After power-on, the device is in normal operating mode by default.
Log in to the ECC800e WebUI as an administrator.
Choose System Settings > PLC, set Enable PLC Function to Yes, and click Submit.
Check all the list items are activated on the Logic List tab page. If any item is not
activated, select the first three items and click Activate.
Choose Monitoring > System > Infrared Remote Control Module.
On the Controls tab page, choose Learning the startup instruction, and click Submit.
Copyright © Huawei Technologies Co., Ltd.
7 Feature Description
164