Table of Contents
Advertisement
Table 43. Assembly material
Description
M3 screw
3
Align the HDD assembly in the chassis.
4
Install the HDD assembly and slide it to seat properly.
5
Secure with the thumb screw.
Figure 31. Installing the 2.5-inch HDD assembly
Next step
1
Complete the procedure listed in After working inside your system.
Removing 3.5-inch hard drive from the rear bay
Prerequisites
NOTE:
The procedure is available only for DSS 9620 server with 3.5-inch HDD.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Complete the procedure listed in Before working inside your system.
CAUTION:
To maintain proper system cooling, all empty hard drive slots must have hard drive blanks installed.
Steps
1
Pull up the plunger and slide the HDD assembly to release from the HDD tray.
Quantity
4 (1 per HDD)
Torque (lbs/inch)
6 ± 0.2
Installing and removing server components
89
Advertisement
Table of Contents
