Dell EMC DSS 9620 Installation And Service Manual page 254

Table 73. Assembly material
Description
#6-32 screw
5 Align the NPIO card with the riser bracket and the riser board connector.
6 Insert the NPIO card in the connector on the riser board.
7 Secure the NPIO card with the provided screw.
NOTE: You must install an expansion card filler cover over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The covers also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
Figure 133. Installing the NPIO card in a bracket
Table 74. Assembly material
Description
#6-32 screw
8 Align the NPIO card assembly with the screw posts on the chassis and the connector on the server board.
9 Press the NPIO card assembly into the server board connector until it is fully seated.
10 Secure the NPIO card assembly with the provided screws.
254 Installing and removing server components
Quantity
2
Quantity
1
Torque (lbs/inch)
6 ± 0.2
Torque (lbs/inch)
6 ± 0.2