Table of Contents
Advertisement
Options to set up iDRAC IP address
To enable communication between your system and iDRAC, you must first configure the network settings based on your network
infrastructure.
NOTE:
For static IP configuration, you must request for it at the time of purchase.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
Dell Integrated Dell Remote Access Controller User's Guide at
utility
Dell Deployment
Dell Deployment Toolkit User's Guide at
Toolkit
Dell Lifecycle
Dell Lifecycle Controller User's Guide at
Controller
CMC Web interface
Dell Chassis Management Controller Firmware User's Guide at
Management Controllers
Server LCD panel
LCD panel
iDRAC Direct and
See Dell Integrated Dell Remote Access Controller User's Guide at
Quick Sync 2
(optional)
iDRAC Direct
See Dell Integrated Dell Remote Access Controller User's Guide at
NOTE:
To access iDRAC, ensure that you connect the ethernet cable to the iDRAC9 dedicated network port. You can also access
iDRAC through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.
NOTE:
To access iDRAC, ensure that you connect the ethernet cable to the iDRAC9 dedicated network port or use iDRAC direct
by using the USB cable. You can also access iDRAC through the shared LOM mode, if you have opted for a system that has the
shared LOM mode enabled.
Log in to iDRAC
You can log in to iDRAC as:
•
iDRAC user
•
Microsoft Active Directory user
•
Lightweight Directory Access Protocol (LDAP) user
If you have opted for secure default access to iDRAC, you must use the iDRAC secure default password available on the system
Information tag. If you have not opted for secure default access to iDRAC, then use the default user name and password –root and
calvin. The default user name and password are root and calvin. You can also log in by using your Single Sign-On or Smart Card.
NOTE:
You must have the iDRAC credentials to log in to iDRAC.
NOTE:
Ensure that you change the default user name and password after setting up the iDRAC IP address.
NOTE:
The Intel Quick Assist Technology (QAT) on the Dell EMC PowerEdge DSS 9620 is supported with chipset integration
and is enabled through an optional license. The license files are enabled on the sleds through iDRAC.
22
Initial system setup and configuration
section
Dell.com/poweredgemanuals
Dell.com/openmanagemanuals
Dell.com/poweredgemanuals
Dell.com/openmanagemanuals
> OpenManage Deployment Toolkit
Dell.com/poweredgemanuals
Dell.com/poweredgemanuals
> Chassis
Advertisement
Table of Contents
