Table of Contents
Advertisement
Miscellaneous Settings details
The Miscellaneous Settings screen details are explained as follows:
Table 35. Miscellaneous Settings
Option
System Time
System Date
Asset Tag
Keyboard NumLock
F1/F2 Prompt on Error
Load Legacy Video Option ROM
In-System Characterization
Dell Wyse P25/P45 BIOS Access
Power Cycle Request
iDRAC Settings utility
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various
iDRAC parameters by using the iDRAC settings utility.
NOTE:
Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals.
46
Pre-operating system management applications
Description
Enables you to set the time on the system.
Enables you to set the date on the system.
Specifies the asset tag and enables you to modify it for security and tracking purposes.
Enables you to set whether the system boots with the NumLock enabled or disabled. This
option is set to On by default.
NOTE:
This option does not apply to 84-key keyboards.
Enables or disables the F1/F2 prompt on error. This option is set to Enabled by default. The
F1/F2 prompt also includes keyboard errors.
Enables you to determine whether the system BIOS loads the legacy video (INT 10H)
option ROM from the video controller. Selecting Enabled in the operating system does not
support UEFI video output standards. This field is available only for UEFI boot mode. You
cannot set the option to Enabled if UEFI Secure Boot mode is enabled.
Enables or disables In-System Characterization. This option is set to Disabled by default.
The two other options are Enabled and Enabled - No Reboot.
NOTE:
The default setting for In-System Characterization is subject to change
in future BIOS releases.
When enabled, In-System Characterization (ISC) executes during POST upon detecting
relevant changes in system configuration to optimize system power and performance. ISC
takes about 20 seconds to execute, and system reset is needed for ISC results to be
applied. The Enabled - No Reboot option executes ISC and continues without applying
ISC results until the next time system reset occurs. The Enabled option executes ISC and
forces an immediate system reset so that ISC results can be applied. It takes the system
longer to be ready due to the forced system reset. When disabled, ISC does not execute.
Enables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled by
default.
Enables or disables the Power Cycle Request. This option is set to None by default.
Advertisement
Table of Contents
