Installation And Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking A Rack System Unpack your system and identify each item. Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system.
Connecting The Power Cable(s) Figure 3. Connecting the Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. Securing The Power Cable(s) Figure 4. Securing the Power Cable(s) Bend the system power cable(s), as shown in the illustration, and attach to the cable strap.
Be sure the operating system is installed before installing hardware or software not purchased with the system. Dell PowerVault Backup to Disk Appliance Powered by CommVault Simpana Release Notes at NOTE: See the support.dell.com/manuals for the latest information.
Before using your system, read the Dell Software License Agreement that came with your system. You must consider any media of Dell-installed software as BACKUP copies of the software installed on your system’s hard drive. If you do not accept the terms of the agreement, call the customer assistance telephone number. For customers in the United States, call 800-WWW-DELL (800-999-3355).
NOTE: (X #), # = Maximum number of power supplies per system. Technical Specifications NOTE: The following specifications are only those required by law to ship with your system. For a complete and current listing of the specifications for your system, go to support.dell.com. Power AC Power Supply (per power supply)
Page 8
10 °C to 35 °C (50 °F to 95 °F) with no direct sunlight on 3117 ft) the equipment NOTE: For information on supported expanded operating temperature range and configurations, Owner's Manual support.dell.com/manuals. see the Humidity Percentage Range 10% to 80% Relative Humidity with 26 °C (78.8 °F) maximum dew point.
Page 9
Environmental NOTE: Applies to data center environments only. NOTE: Air entering the data center must have Air filtration requirements do not apply to IT MERV11 or MERV13 filtration. equipment designed to be used outside a data center, in environments such as an office or factory floor.