Table of Contents
Advertisement
Option
System Management Engine Version
System Service Tag
System Manufacturer
System Manufacturer Contact Information
System CPLD Version
UEFI Compliance Version
Memory Settings
You can use the Memory Settings screen to view all the memory settings and enable or disable specific memory functions, such as system
memory testing and node interleaving.
Viewing Memory Settings
About this task
To view the Memory Settings screen, perform the following steps:
Steps
1
Turn on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
your system and try again.
3
On the System Setup Main Menu screen, click System BIOS.
4
On the System BIOS screen, click Memory Settings.
Memory Settings details
The Memory Settings screen details are explained as follows:
Table 29. The Memory Settings screen details are explained as follows:
Option
System Memory Size
System Memory Type
System Memory Speed
System Memory Voltage
Video Memory
System Memory Testing
Description
Specifies the current version of the Management Engine firmware.
Specifies the system Service Tag.
Specifies the name of the system manufacturer
Specifies the contact information of the system manufacturer.
Specifies the current version of the system complex programmable logic device (CPLD)
firmware.
Specifies the UEFI compliance level of the system firmware.
Description
Specifies the memory size in the system.
Specifies the type of memory installed in the system.
Specifies the system memory speed.
Specifies the system memory voltage.
Specifies the amount of video memory.
Specifies whether the system memory tests are run during system boot. Options are
Enabled and Disabled. This option is set to Disabled by default.
Pre-operating system management applications
35
Advertisement
Table of Contents
