Reflect Between-Clients (Bgp View); Reflector Cluster-Id (Bgp View) - H3C S9500 Series Command Manual

Command Manual – BGP
H3C S9500 Series Routing Switches
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1] preference 20 20 200

1.1.70 reflect between-clients (BGP view)

Syntax
reflect between-clients
undo reflect between-clients
View
BGP view
Default Level
2: System level
Parameters
None
Description
Use the reflect between-clients command to enable route reflection between clients.
Use the undo reflect between-clients command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the
clients of a route reflector are fully meshed, you need disable route reflection between
clients to reduce routing costs.
Related commands: reflector cluster-id, peer reflect-client.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] undo reflect between-clients

1.1.71 reflector cluster-id (BGP view)

Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
Chapter 1 BGP Configuration Commands
1-71