Refresh Bgp - H3C S9500 Series Command Manual

Command Manual – BGP
H3C S9500 Series Routing Switches
View
BGP view
Default Level
2: System level
Parameters
cluster-id: Cluster ID of the route reflector, a decimal integer or an IP address.
Description
Use the reflector cluster-id command to configure the cluster ID of the route reflector.
Use the undo reflector cluster-id command to remove the configured cluster ID.
By default, each route reflector uses its router ID as the cluster ID.
Usually, there is only one route reflector in a cluster. The router ID of the route reflector
is the ID of the cluster. You can configure multiple route reflectors to improve the
stability of the network. In this case, using this command can configure the identical
cluster ID for all the route reflectors to avoid routing loops.
Related commands: reflect between-clients, peer reflect-client.
Examples
# Set the cluster ID to 80.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] reflector cluster-id 80

1.1.72 refresh bgp

Syntax
refresh bgp { all | ip-address | group group-name | external | internal } { export |
import }
View
User view
Default Level
1: Monitor level
Parameters
all: Soft-resets all BGP connections.
ip-address: Soft-resets the BGP connection to a peer.
Chapter 1 BGP Configuration Commands
1-72