Default Ipv4-Unicast - H3C S9500 Series Command Manual

Command Manual – BGP
H3C S9500 Series Routing Switches
*Aug 24 14:12:13:674 2006 Sysname RM/6/RMDEBUG:
BGP_L3VPN: Recv UPDATE with following RD 100:1 destination 11.1.1.1 - Received
New VPNv4 Route with Ext-Community NULL..Ignoring Route
// BGP received an UPDATE message with RD 100:1, destination address 11.1.1.1.
The Ext-Community of the new VPNv4 route is NULL and therefore the route was
ignored.
DeLocRemCross: Deleting route From Target Instance.
// The route was deleted from the instance.

1.1.13 default ipv4-unicast

Syntax
default ipv4-unicast
undo default ipv4-unicast
View
BGP view
Default Level
2: System level
Parameters
None
Description
Use the default ipv4-unicast command to enable the use of IPv4 unicast address
family for all peers.
Use the undo default ipv4-unicast command to disable the use of IPv4 unicast
address family for all peers.
The use of IPv4 unicast address family is enabled by default.
Examples
# Enable IPv4 unicast address family for all neighbors.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default ipv4-unicast
Chapter 1 BGP Configuration Commands
1-14