H3C S9500 Series Command Manual page 16

Command Manual – BGP
H3C S9500 Series Routing Switches
Parameters
ip-address: IP address of a peer.
all: Enables all BGP debugging.
detail: Enables BGP detailed information debugging.
event: Enables BGP event debugging.
graceful-restart: Enables BGP GR debugging.
timer: Enables BGP timer debugging.
keepalive: Enables BGP keepalive packets debugging.
open: Enables BGP open packets debugging.
packet: Enables BGP packets debugging.
raw-packet: Enables BGP raw packets debugging.
route-refresh: Enables BGP route-refresh packets debugging.
receive: Received BGP packets.
send: Sent BGP packets.
Verbose: Displays detailed debugging information.
update: Enables BGP update packets debugging.
acl acl-number: Uses an ACL to filter output packet debugging information.
ip-prefix ip-prefix-name: Uses an IP prefix list to filter output packet debugging
information.
ipv4: Enables IPv4 packet debugging.
l2vpn: Enables L2VPN packet debugging.
label-route: Enables labeled BGP route debugging.
vpnv4: Enables VPNv4 packet debugging.
vpn-instance vpn-instance-name: Enables packet debugging for the VPN instance.
peer ip-address/group-name: Enables BGP packet debugging with the BGP peer or
peer group.
Description
Use the debugging bgp command to enable specified BGP debugging.
Use the undo debugging bgp command to disable specified BGP debugging.
Enabling any debugging will decrease system performance; therefore, disable the
debugging timely after debugging.
Examples
# Enable BGP detailed debugging when a BGP peer relationship is being established.
<Sysname> debugging bgp detail
Chapter 1 BGP Configuration Commands
1-13