Peer Fake-As (Bgp/Bgp-Vpn Instance View) - H3C S9500 Series Command Manual

Command Manual – BGP
H3C S9500 Series Routing Switches
Default Level
2: System level
Parameters
ip-address: IP address of a peer.
Description
Use the peer enable command to enable the specified peer.
Use the undo peer enable command to disable the specified peer.
By default, the BGP peer is enabled.
If a peer is disabled, the device will not exchange routing information with the peer.
Examples
# Disable peer 18.10.0.9.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 18.10.0.9 group group1
[Sysname-bgp] undo peer 18.10.0.9 enable

1.1.52 peer fake-as (BGP/BGP-VPN instance view)

Syntax
peer { group-name | ip-address } fake-as as-number
undo peer { group-name | ip-address } fake-as
View
BGP view, BGP-VPN instance view
Default Level
2: System level
Parameters
group-name: Name of a peer group.
ip-address: IP address of a peer.
as-number: Local autonomous system number.
Description
Use the peer fake-as command to configure a fake local AS number for a peer or peer
group.
Use the undo peer fake-as command to remove the configuration.
Chapter 1 BGP Configuration Commands
1-53