Committing Changes To Memory; Shutting Down - Extron electronics Quantum Ultra User Manual

Committing Changes to Memory

The Quantum Ultra Control Panel enables you to commit (save) to memory all changes
made to the
settings remain in effect the next time the Quantum Ultra is powered on.
NOTE: You must have administrator clearance in order to commit changes.
1.
2.
3.

Shutting Down

If required, use one of the following methods to shut down the Quantum Ultra:
•
•
•
To perform an optional orderly shutdown:
drive and operating system configuration during the session. These saved
C:
On the
Quantum Ultra Control Panel
. The following window opens:
Commit Changes
Figure 53. Reboot Confirmation Prompt to Commit Changes
Click to reboot the unit.
OK
On the
Password Verification
click . The system reboots and your changes are saved.
Enter
ATTENTION:
•
While the processor is rebooting, do not press any keys or attempt to power
off the system.
• Pendant la réinitialisation du processeur, n'appuyez sur aucune touche et
n'essayez pas d'éteindre le système.
When the reboot is complete, the Quantum Ultra
displayed. All the settings are saved to memory and remain in effect until changed.
When a keyboard, mouse, and monitor are attached, the Quantum Ultra can be shut
down via the Control Panel.
If logged into the Quantum Ultra operating system, momentarily press the rear panel
power switch.
Press and hold the rear panel power switch for 5 seconds (see
on page 11).
1. Click . A confirmation prompt appears:
Shut down
Figure 54. Shutdown Confirmation Prompt
2. Click . The Quantum Ultra shuts down.
OK
Quantum Ultra Videowall Processing System • Operation
window (see figure 37,
window, enter the administration password and
Control Panel
, on page 37) click
6
main window is
figures 4 and 5, ,
C
48