Table 11-1 Alarm Configurations - Honeywell HED2PER3 Configuration Manual

Performance Series IP Camera Software Configuration Guide

Table 11-1 Alarm Configurations

Type Parameter
Motion Detection
Disk Full
Video Tampering
Alarm Type
Disk Error
Illegal Access
Scene Change
Operation Prompt
Play Alarm Sound
Alarm Sound
Alarm Sound Path
78
Function
Check to enable Motion Detection. The system will then trigger an
alarm when motion is detected under the specified circumstances.
Check to enable Disk Full. The system will then trigger an alarm when
the disk (microSD card) is full.
Note This function is not supported by the following models:
HPW2P1/HBW2PER1.
Check to enable Video Tampering. The system will then trigger an
alarm when the camera has been tampered with.
Check to enable Disk Error. The system will then record alarm
information when a microSD card error occurs.
Note This function is not supported by the following models:
HPW2P1/HBW2PER1.
Check to enable Illegal Access. The system will then trigger an alarm
when someone attempts to illegally access the camera.
Check to enable Scene Change. The system will then trigger an
alarm when the camera scene change event occurs.
Check to enable Prompt. The system will then automatically pop up an
alarm message on the main window when there is an alarm.
Check to enable Play Alarm Sound. When an alarm occurs, the system
automatically generates an audible sound. You can select a sound from
your PC for the alarm sound prompt.
Select the alarm sound file.