Configuring Camera Tampering Settings; Figure 7-4 Video Tampering; Table 7-2 Tampering Configurations - Honeywell HED2PER3 Configuration Manual

Performance series ip cameras
Hide thumbs Also See for HED2PER3:
Table of Contents

Advertisement

4. Select a threshold value, from 1 to 100 for each region. The higher the number, the more
motion will be needed to trigger a motion event. It is recommended that you choose a
sensitivity between 5 to 50.
5. Click Remove All to delete all motion detection regions. Click Delete to delete the selected
motion detection region.
6. Click OK to save the configurations. Click Cancel to exit the setup without saving the
changes.

Configuring Camera Tampering Settings

Go to Setup Video Analytics Video DetectionVideo Tampering.

Figure 7-4 Video Tampering

Table 7-2 Tampering Configurations

Parameter
Enable
Tamper
Detection
Enable
Defocus
Detection
Alarm
Period
Record
Record
Delay
Send Email
Function
Check to enable video tamper detection.
Check to enable defocus detection.
Note
Defocus Detection is only supported by the following models:
HEW4PER2/HEW2PER2/H4W2PER2/HBW2PER2/H4W8PR2/HBW8PR2.
The camera tampering function is activated during the specified period.
See
Configuring the Alarm Period
You can configure up to six periods per day. Select a date. If you do not
select a date, the current setup will be applied to today only. You can
select All to apply the alarm period to the whole week.
Click OK to save the changes. The system goes back to the video
tampering interface. Click Save to exit.
If Record is enabled, a camera tampering event can activate recording.
The system will wait for the specified time before it begins recording. Select
from 10s to 300s.
When enabled, the system sends an email alert when an alarm occurs.
Configuring Video Analytics
on page 47.
49

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents