Configuring Scene Change Settings; Figure 7-5 Scene Change; Table 7-3 Scene Change Configurations - Honeywell HED2PER3 Configuration Manual

Performance Series IP Camera Software Configuration Guide
Snapshot

Configuring Scene Change Settings

Go to Setup Video Analytics Video DetectionScene Change.

Figure 7-5 Scene Change

Table 7-3 Scene Change Configurations

Parameter Function
Enable Check to enable scene change.
The camera scene change function is activated during the specified period.
See
You can configure up to six periods per day. Select a date. If you do not
Alarm
select a date, the current setup will be applied to today only. You can
Period
select All to apply the alarm period to the whole week.
Click OK to save the changes. The system goes back to the scene change
interface. Click Save to exit.
Record If Record is enabled, a scene change event can activate recording.
Record The system will wait for the specified time before it begins recording. Select
Delay from 10s to 300s.
Send
When enabled, the system sends an email alert when an alarm occurs.
Email
When enabled, the system attaches a snapshot to an email alert when an
Snapshot
alarm occurs.
50
When enabled, the system attaches a snapshot to an email alert when an
alarm occurs.
Configuring the Alarm Period on page 47.