Performance Series IP Camera Software Configuration Guide
Table 6-3 SMTP (Email) Configurations
Parameter
SMTP Server
Port
Anonymous
User Name
Password
Sender
Authentication
Title
Attachment
Mail Receiver
Send Health
Messages
Interval
Email Test
Configuring UPnP Settings
Go to Setup Network Setup UPnP.
UPnP lets you establish the mapping relationship between the LAN and the public network. In
the UPnP configuration interface, you can add, modify, or remove a UPnP item.
38
Function
Enter the server address.
The default setting is 25. You can modify this setting as
necessary.
Supports the anonymity function for the server. You can
automatically log in anonymously. You do not need to enter the
user name, password, and the sender information.
Enter the username for the sender's email
Enter the password for the sender's email
Enter the sender's email address.
This is the encryption mode. Select SSL, TLS, or None.
Enter the email subject.
Select the check box to have the system send out a snapshot
with the email.
Enter the receiver's email address here. You can enter up to
three addresses.
To have the system periodically verify that the email notification
settings are working, select the Send Health Messages check
box, and specify the Interval.
The interval for sending ranges from 0 to 3600 seconds. 0
seconds means that there is no interval.
The system will not immediately send the email when the alarm
occurs. When an alarm, motion detection, or other event occurs
to activate an email, the system sends the email according to
the interval that you have specified here. This reduces the load
on the email server when multiple emails are triggered
simultaneously.
The system will automatically send an email to test the
connection.
Before you can do an email test, you must save the email setup
information.