Figure 7-3 Configuring The Motion Detection Area - Honeywell HED2PER3 Configuration Manual

Performance Series IP Camera Software Configuration Guide
•
Note
•
2. Configure a time range for when the motion detection is active, and then click the Period
check box to select that time range for the selected day of the week.
3. Repeat steps 1 and 2 to set up multiple time periods in a day or to setup other days of the
week, as required.
4. Click OK.
Method 2:
Use the green bar to configure the time periods needed for motion detection. Click the green
bar to disable the time and day, drag on the target time and day to enable them.
Configuring the Motion Detection Area

Figure 7-3 Configuring the Motion Detection Area

Perform the following steps to configure the motion detection area:
1. Select the motion detection region from the 4 regions (red, yellow, blue and green). You
can configure 4 different regions of motion detection. If necessary, enter a name for the
region in the name field.
2. Select the detection area by clicking and dragging the mouse over the video image.
There are 396 (PAL) or 330 (NTSC) small areas. The color of the area tile indicates which
region is set for motion on that area. If there is no color, then motion detection is not set
for that area.
3. Select a sensitivity value, from 1 to 100 for each region. The higher the number, the higher
the motion detection sensitivity. It is recommended that you choose a sensitivity between
30 to 70. The default is 60.
48
If you select All, the schedule will apply to all days of the week.
You can configure up to 6 periods within a day.