Figure 7-2 Configuring The Alarm Period - Honeywell HED2PER3 Configuration Manual

Performance series ip cameras
Hide thumbs Also See for HED2PER3:
Table of Contents

Advertisement

Parameter
Function
Enter the anti-dither time in seconds. Enter a value between 0
Anti-Dither
and 100 seconds. The system will only allow one motion
detection event within this period.
Configure the motion detection region, its sensitivity, and area. The
Area
default settings covers the entire area. Click Save to enable these
settings. See
Click the checkbox to enable Record. You can trigger motion detection to
Record
activate recording.
The system can delay recording for a specified time after the alarm has
Record Delay
ended. Choose a delay period from 10s to 300s.
Click the checkbox to enable Send Email. The system will then send an
Send Email
email alert when an alarm occurs.
Click the checkbox to enable Snapshot. The system will then back up
Snapshot
motion detection snapshot files. (See
configure the path where snapshots are saved.)
Configuring the Alarm Period
Define a period during which motion detection is active.

Figure 7-2 Configuring the Alarm Period

Perform either of the following methods to configure the alarm period:
Method 1:
1. Select a day of the week check box. Select from a day of the week or All.
Configuring the Motion Detection Area
Configuring Video Analytics
on page 48.
Path
on page
61
for how to
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents