HPW2P1 WDR 1080P Pin-hole Camera
Quick Installation Guide
Thank you for purchasing a Honeywell Performance Series IP camera.
Follow the instructions in this guide to install and log in to your camera.
For instructions on configuring the camera, refer to the Performance
Series IP Cameras User Guide on the installation CD that came with your
If you require additional assistance, contact Tech Support (contact info
is listed on the back page).
Cautions and Warnings
RISK OF ELECTRIC
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE THE COVER.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
To ensure compliance with electrical safety standards, this product is intended
for use with a Listed Power Adapter marked "Limited Power Source" or "LPS" on
the unit, output rated to 12 VDC, minimum 0.33 A, TMA=60 deg C, or from Power
over Ethernet (PoE) provided by Listed Information Technology Equipment
meeting IEEE 802.3af PoE standard.
The Ethernet connection is not intended to be connected to exposed (outside
plant) networks. Do not connect two power sources to the camera at the same
Invisible LED radiation (850 nm). Avoid exposure to beam.
Read and keep these instructions.
Do not aim the camera toward a bright light source for extended periods to prevent damage to
the imager. Avoid operating the unit under or close to unstable light sources (may cause
flickering), or close to fluorescent lamps or objects reflecting light.
Do not touch the camera lens.
Do not drop the camera or subject it to physical shock.
Do not use a strong or abrasive detergent when cleaning the camera.
THIS SYMBOL INDICATES THAT
CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.
THIS SYMBOL INDICATES THAT
IMPORTANT OPERATING AND
ACCOMPANY THIS UNIT.
Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where
the operating temperature is outside the recommended range of -22°F to 140°F (–30°C to
Do not apply power to the camera before completing installation.
Confirm the installation surface can support at least three times the weight of the
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing
or damaged, contact your dealer immediately.
Preparing the Mounting Surface and Mounting the Camera
Inspect the site where you want to install the camera. The mounting surface must be flat and
capable of supporting at least three times the weight of the camera.
Install the camera together with the bracket on the mounting surface and secure the
installation screws firmly.
Connect the camera's connectors to power, network and audio in/out.
Adjust the camera angle and tighten the adjusting screws.
Logging On to the Camera
If the camera is connected to the PoE port of a Honeywell Embedded NVR, you can log on to the
camera directly from the NVR.
Quick installation guide
Power 12 VDC
(Yellow) Audio Out