Canon Finisher-R1 Service Manual page 117

Chapter 4
When the tray lift motor gear clutch is released the
tray drops by its own weight. Therefore, hold the
tray with your hand when releasing the clutch.
Also, be careful not to twist the tray cable when
installing.
F-4-147
4.3.6.7 Removing the Grate-
shaped Lower Guide
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.
4-42
[1]
4.3.6.8 Removing the Stapler
1) Pull out the stapler, remove screw [1], and remove
the PCB cover [2].
0004-4667
2) Release the claw [3] and remove the PCB [4].
3) Disconnect three connectors [5].
4) Remove screw [6] and remove the stapler together
with the stapler base [7].
When removing, be careful not to damage the flag
[8].
[2]
F-4-148
F-4-149
[1]
[1]
0004-4669