Tray 1 - Canon Finisher-R1 Service Manual

Chapter 4
F-4-81
7) Disconnect the connector [16] and remove harness
from the clamp and edge saddle [17].
8) Remove two screws [18] and pull out the
processing tray [19] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-4-82

4.3.2 Tray 1

4.3.2.1 Removing the Front
Cover
1) Remove screw [1] and remove the foot cover [2].
4-24
2) Open the front door [3] and remove three screws
[4].
3) Remove the front cover [5].
4.3.2.2 Removing the Rear
Cover
1) Remove three screws [1] and remove the rear cover
[2].
0004-8072
[1]
F-4-83
[3]
[5]
F-4-84
[2]
[4]
0004-4551