Canon Finisher-R1 Service Manual page 96

2) Remove screw [4] and remove the stopper [5].
F-4-71
3) Remove two screws [6], open two harness retainers
[7] and disconnect two connectors [8].
F-4-72
4) Insert your finger in the hole at the rear side of tray
1 [9], push the tray lift motor gear [10] to the front to
release the clutch and lift tray 1 [9].
When the tray lift motor gear clutch is released, the
tray drops by its own weight. Therefore, hold the
tray with your hand when releasing the clutch.
Also, be careful not to twist the tray cable when
installing.
F-4-73
4.3.1.6 Removing the Tray 2
When you attach or remove the tray, please be sure
to raise the shutter [1], release the latch [3] on the
rear surface of the tray while the stack delivery gate
[2] of the delivery opening is lifted (covered), and
then move down the tray. If you move down the
tray without lifting the shutter of the delivery
opening, the stack delivery gate comes off from the
Finisher. If the stack delivery gate comes off,
remount it while paying attention so as not to lose
the spring for the shaft of the stack delivery gate.
The tray falls by its own weight when the latch is
released, so be sure to hold the tray with hands.
Chapter 4
0004-4583
4-21