Canon Finisher-R1 Service Manual page 112

[8].
The parallel pin [6] drops when the gear [5] is
removed. Be careful not to loose it.
F-4-129
3) Remove all finisher controller PCB connectors[9].
4) Remove four screws [10]. Remove the screw [11]
securing the ground wire and remove the finisher
controller PCB [12].
F-4-130
5) Release the claw [13] of the stack delivery roller
rear side clutch [12] and remove the clutch [12].
6) Remove the E ring [14] and bushing [15] and
remove the stack delivery roller.
F-4-131
7) Disconnect the connector [16] and remove harness
from the clamp and edge saddle [17].
8) Remove two screws [18] and pull out the
processing tray [19] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-4-132
4.3.5.9 Removing the Return
Roller
The return roller is subjected to special production
processing known as "aging" to prevent possible
increases in its feeding power. Do not clean the
Chapter 4
0004-4646
4-37