Canon Finisher-R1 Service Manual page 92

[8].
The parallel pin [6] drops when the gear [5] is
removed. Be careful not to loose it.
F-4-57
3) Remove all finisher controller PCB connectors[9].
4) Remove four screws [10]. Remove the screw [11]
securing the ground wire and remove the finisher
controller PCB [12].
F-4-58
5) Release the claw [13] of the stack delivery roller
rear side clutch [12] and remove the clutch [12].
6) Remove the E ring [14] and bushing [15] and
remove the stack delivery roller.
F-4-59
7) Disconnect the connector [16] and remove harness
from the clamp and edge saddle [17].
8) Remove two screws [18] and pull out the
processing tray [19] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-4-60
4.2.2.9 Removing the Swing
Unit
1) Remove screw [1] and pull up the swing pressure
guide [2].
Chapter 4
0004-4588
4-17