Chapter 4
When the tray lift motor gear clutch is released the
tray drops by its own weight. Therefore, hold the
tray with your hand when releasing the clutch.
Also, be careful not to twist the tray cable when
installing.
F-4-126
4.3.5.7 Removing the Grate-
shaped Lower Guide
1) Remove ten screws [1] and remove the grate-
shaped lower guide [2].
When replacing, be careful not to hook the grate-
shaped lower guide to the sensor flag arm on the
delivery side.
4-36
[1]
4.3.5.8
Processing Tray
1) Unfasten four snap fasteners [1] and remove the
sensor flag [3] from the stack delivery roller [2].
Hold the snap fastener at the base when
unfastening because the sensor flag arm can break
0004-4640
easily. When fastening, insert the boss of the sensor
flag snap fastener in the hole on the processing tray
side.
2) Remove the stack delivery roller front side E ring
[4], gear [5], parallel pin [6], E ring [7], and bushing
[2]
F-4-127
Removing
F-4-128
[1]
[1]
the
0004-4645