Canon Finisher-R1 Service Manual page 66

Chapter 3
1) Open the front cover; then, from the back of the
front cover, remove the fixing screw, and detach the
pliers [1].
[1]
F-3-33
■ Adjusting the Height
1) Loosen the 2 fixing screws [1] each of the casters at
the front and rear of the finisher pickup side.
2) If you want to increase the height of the finisher,
turn the adjusting bolt [2] in the direction of arrow A
of the figure. (A full turn of the adjusting bolt will
increase the height of the finisher by 1.75 mm.) Refer
to the index in the caster area when adjusting the
height. Perform this for both front and rear casters.
3) If you want to decrease the height of the finisher,
turn the adjusting bolt [2] in the direction of arrow B.
(A full turn of the adjusting bolt will decrease the
height of the finisher by 1.75 mm.) Refer to the index
in the caster area when adjusting the height. Perform
this for both front and rear casters.
3-14
[1]
F-3-34
■ Adjust the Tilt
1) Loosen the 2 fixing screws [1] 2 each on the front
and rear casters of the finisher delivery side.
2) If you want to decrease the gap between the finisher
and its hot machine, turn the adjusting bolt [2] in the
direction of A. (A full turn will increase the height of
the finisher by 1.75 mm.)
3) If you want to increase the gap between the finisher
and its host machine, turn the adjusting bolt [2] in the
direction of arrow B. (A full turn of the adjusting bolt
will decrease the height of the finisher by 1.75 mm.)
Adjust the tilt by referring to the index in the caster
area. Perform this for both front and rear casters.
[1]
F-3-35
■ Making Checks After Making Adjustments
[2]
B
A
[2]
B
A