Canon Finisher-R1 Service Manual page 103

Chapter 4
F-4-96
When replacing, hook the two claws [4] of the left
upper cover to the steel plate.
F-4-97
4.3.3.4 Removing the Tray 1
When you attach or remove the tray, please be sure
to raise the shutter [1], release the latch [3] on the
rear surface of the tray while the stack delivery gate
[2] of the delivery opening is lifted (covered), and
then move down the tray. If you move down the
tray without lifting the shutter of the delivery
opening, the stack delivery gate comes off from the
Finisher. If the stack delivery gate comes off,
remount it while paying attention so as not to lose
the spring for the shaft of the stack delivery gate.
The tray falls by its own weight when the latch is
released, so be sure to hold the tray with hands.
4-28
[3]
[2]
[1]
1) Remove screw [1] and remove the steel plate [2]
and slide guide [3]. However, if the grate-shaped
upper guide is removed, this step is not necessary.
0004-4564
2) Remove screw [4] and remove the stopper [5].
F-4-98
F-4-99