Canon Finisher-R1 Service Manual page 100

[2]
[1]
F-4-85
4.3.2.3 Removing the Left
Upper Cover
1) Remove two screws [1].
2) With the upper door [2] open, remove the left upper
cover [3] by tilting to the right.
F-4-86
When replacing, hook the two claws [4] of the left
upper cover to the steel plate.
4.3.2.4 Removing the Tray 1
When you attach or remove the tray, please be sure
to raise the shutter [1], release the latch [3] on the
0004-4552
rear surface of the tray while the stack delivery gate
[2] of the delivery opening is lifted (covered), and
then move down the tray. If you move down the
tray without lifting the shutter of the delivery
opening, the stack delivery gate comes off from the
Finisher. If the stack delivery gate comes off,
remount it while paying attention so as not to lose
the spring for the shaft of the stack delivery gate.
The tray falls by its own weight when the latch is
released, so be sure to hold the tray with hands.
Chapter 4
F-4-87
0004-4554
4-25