Static Charge Eliminator 1 - Canon Finisher-T1 Service Manual

Chapter 3
3.4.2 Static Charge Eliminator
1
3.4.2.1 Removing the
Front Door
Refer to Procedure 3.1.5
3.4.2.2
Removing the
Rear Upper Cover
Refer to Procedure 3.1.1
3.4.2.3
Removing the
Escape Tray Cover
Refer to Procedure 3.1.6
3.4.2.4 Removing the
Front Inside Upper
Cover
Refer to Procedure 3.1.4
3.4.2.5
Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.2
3.4.2.6
Removing the
Tray 1
Refer to Procedure 3.3.2
3-22
0009-4529
0009-4531
0009-4440
0009-4532
Upper
0009-3703
0009-3704
3.4.2.7 Removing the
Tray 2
Refer to Procedure 3.3.3
3.4.2.8 Removing the
Grate-shaped
Guide
Refer to Procedure 3.1.3
3.4.2.9
Removing the
Stapler
Refer to Procedure 3.2.1
3.4.2.10 Removing the
Processing Tray
Refer to Procedure 3.3.1
3.4.2.11 Removing the
Swing Unit
Charge Eliminator
1) Remove the screw [1] securing the static
charge eliminator at the center of the swing
unit.
2) Remove two screws [2] securing the
ground of the delivery side static charge
eliminator.
0009-3705
Lower
0009-4533
0009-3707
0009-3708
Static
0009-3697