Canon Finisher-R1 Service Manual page 101

Chapter 4
[3]
[2]
[1]
F-4-88
1) Remove screw [1] and remove the steel plate [2]
and slide guide [3]. However, if the grate-shaped
upper guide is removed, this step is not necessary.
F-4-89
2) Remove screw [4] and remove the stopper [5].
4-26
F-4-90
3) Remove two screws [6], open two harness retainers
[7] and disconnect two connectors [8].
F-4-91
4) Insert your finger in the hole at the rear side of tray
1 [9], push the tray lift motor gear [10] to the front to
release the clutch and lift tray 1 [9].
When the tray lift motor gear clutch is released, the
tray drops by its own weight. Therefore, hold the
tray with your hand when releasing the clutch.
Also, be careful not to twist the tray cable when
installing.