Preparing The Host Machine For Installation - Canon Finisher-R1 Service Manual

Finisher, sorter, deliverytray
Hide thumbs Also See for Finisher-R1:
Table of Contents

Advertisement

1) Mount the rail [1] to the finisher using 2 screws [2]
(binding; M4x6).
F-3-19
3.2.2.2
Preparing the Host
Machine for Installation
Be sure to mount the inlet guide and the fixing
plate before connecting the finisher to its host
machine.
1) If a delivery tray is found on the delivery assembly
of the host machine, remove it.
2) Remove the 3 screws [1], and detach the left cover
[2] of the host machine.
3) Cut off the 2 face covers [3] of the left cover using
nippers; then, mount the left cover to the machine.
[3]
[1]
F-3-20
[1]
[2]
0003-1762
[2]
4) Slide the inlet guides upper [1] and lower [2] to the
delivery assembly of the host machine; then, fix it in
place using a screw [3] (1 pc. each; tapping; M4x12).
[1]
[2]
[3]
F-3-21
5) Mount the front fixing plate [1] and the rear fixing
plate [2] using 2 screws each [3] (binding; M4x6).
If you are installing a puncher unit, be sure to
mount the fixing plate that comes with the unit as
instructed in the Puncher Unit Installation
Procedure.
<Finisher-R1>
Use FC5-4196 for both fixing plates [1] and [2].
[2]
[3]
[3]
F-3-22
<Saddle Finisher-R2>
Chapter 3
[1]
3-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents